Jacking And Tire Changing; Jack Location/Spare Tire Stowage - Jeep RENEGADE 2016 User Manual

Hide thumbs Also See for RENEGADE 2016:
Table of Contents

Advertisement

WHAT TO DO IN EMERGENCIES

JACKING AND TIRE CHANGING

• Do not attempt to change a tire on the side of the vehicle close to moving
traffic. Pull far enough off the road to avoid the danger of being hit when
operating the jack or changing the wheel.
• Being under a jacked-up vehicle is dangerous. The vehicle could slip off the
jack and fall on you. You could be crushed. Never put any part of your body
under a vehicle that is on a jack. If you need to get under a raised vehicle, take
it to a service center where it can be raised on a lift.
• Never start or run the engine while the vehicle is on a jack.
• The jack is designed to be used as a tool for changing tires only. The jack
should not be used to lift the vehicle for service purposes. The vehicle should
be jacked on a firm level surface only. Avoid ice or slippery areas.

Jack Location/Spare Tire Stowage

The jack and tools are located in the rear storage compartment if equipped, inside a
special container.
1. Open the liftgate.
2. Lift the access cover using the load
floor pull strap.
3. Remove the fastener securing the
spare tire.
4. Remove the chocks.
5. Remove the jack and wheel bolt
wrench.
6. Remove the spare tire.
WARNING!
Jack And Tools Location
Jack And Tools
173

Advertisement

Table of Contents
loading

Table of Contents