Table of Contents
Advertisement
WHAT TO DO IN EMERGENCIES
– Forward Collision Warning (FCW) OFF Indicator
NOTE:
• The default status of FCW is "On." This allows the system to warn you of a possible
collision with the vehicle in front of you.
• The forward collision button is located on the switch panel below the Uconnect
display.
To turn the FCW system OFF, push the forward collision button once to turn the
system OFF (led turns on).
Refer to "Electronic Speed Control" in "Operating Your Vehicle" for further informa-
tion on Forward Collision Warning (FCW) operation and proper use.
– Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The Oil Change
telltale and message (Oil Change Required) will display in the EVIC/DID display for
approximately 5 seconds, after a single chime has sounded, to indicate the next
scheduled oil change interval. The engine oil change indicator system is duty-cycle
based, which means the engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition
switch to the MAR/RUN position for vehicles not equipped with Keyless Enter-N-Go,
or cycle the ignition to the ON/RUN position for vehicles equipped with Keyless
Enter-N-Go. To turn off the message temporarily, push and release the MENU button.
To reset the oil change indicator system (after performing the scheduled mainte-
nance), refer to the following procedure:
Vehicles Equipped With Keyless Enter-N-Go
1. Without pushing the brake pedal, push the ENGINE START/STOP button and
cycle the ignition to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the MAR/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the STOP/OFF position.
NOTE:
If the indicator message illuminates when you start the engine, the oil change
indicator system did not reset. If necessary, repeat these steps.
168
Advertisement
Table of Contents
