Table of Contents
Advertisement
To Send A Text Message:
1. Push the Uconnect Phone Button
2. Wait for the beep.
3. Say "Text."
4. Uconnect will prompt you "Say the phone number, or full name and phone type
of the contact you want to send a message to."
5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone
number that you would like to send the message to.
6. Uconnect will prompt you "Please say the message that you would like to send."
(If you do not hear this prompt, you may not have an active subscription with
Uconnect Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you
exceed 140 characters, you will hear the following prompt: "Message was too
long; your message will be truncated."
8. Uconnect will then repeat the message back to you.
9. Uconnect will prompt you: "To add to your message, say "Continue;" To delete the
current message and start over, say "Start Over;" to send the current message, say
"Send;" to hear the message again, say "Repeat."
10. If you are happy with your message and would like to send it, wait for the beep
and say "Send."
11. Uconnect will then say "Sending your message."
Sample Commands For Voice Text Reply And Voice Texting
Example Command
"Text John Smith"
"Text 123 456 7890"
"Show messages"
"Listen to/view (message number four, for
example)"
"Reply"
"Forward text/message to "John Smith"
"Forward text/message to
"123 456 7890"
ELECTRONICS
on the steering wheel.
Action
Send a message to specific contact in
address book
Send 123 456 7890 a message from
your phonebook
See recent text messages listed by
number on Uconnect screen
Hear messages or read it on Uconnect
screen
Send a voice text reply to a current
message
Forward current text to specific contact in
address book
Forward current text to specific phone
number
91
Advertisement
Table of Contents
