Table of Contents
Advertisement
OPERATING YOUR VEHICLE
High Beams
To turn on the high beam headlights, push the turn signal lever forward (toward the
front of the vehicle) and an indicator will illuminate in the cluster. To turn off the high
beams, pull the turn signal lever rearward (toward the rear of the vehicle).
NOTE:
The headlights must be on for the high
beams to activate.
Turn Signals
Move the multifunction lever up or down
and the arrows on each side of the instru-
ment cluster flash to show proper opera-
tion of the front and rear turn signal
lights.
NOTE:
When the Daytime Running Lights are on
and a turn signal is activated, the Daytime Running Lamp will turn off on the side of
the vehicle in which the turn signal is flashing. The Daytime Running Lamp will turn
back on when the turn signal is turned off.
WIPERS AND WASHERS
The windshield wiper/washer controls are located on the lever on the right side of the
steering column. The front wipers are operated by rotating a switch, located on the
end of the lever.
Always remove any buildup of snow that prevents the windshield wiper blades
from returning to the "park" position. If the windshield wiper switch is turned off,
and the blades cannot return to the "park" position, damage to the wiper motor
may occur.
High Beam And Turn Signal Controls
Windshield Wiper Stalk
CAUTION!
41
Advertisement
Table of Contents
