Table of Contents
Advertisement
OPERATING YOUR VEHICLE
Front Wiper Operation
Rotate the windshield wiper knob to one of the two detent positions for intermittent
settings, the third detent for low wiper operation and the fourth for high wiper
operation.
Windshield Washer Operation
To use the washer, pull the lever toward you and hold while spray is desired. If the
lever is pulled while in the intermittent setting, the wipers will turn on and operate for
several wipe cycles after the lever is released, and then resume the intermittent
interval previously selected.
If the lever is pulled while the wipers are in the off position, the wipers will operate
for several wipe cycles, then turn off.
Sudden loss of visibility through the windshield could lead to a collision. You
might not see other vehicles or other obstacles. To avoid sudden icing of the
windshield during freezing weather, warm the windshield with the defroster before
and during windshield washer use.
Mist
Use this feature when weather conditions make occasional usage of the wipers
necessary. Push the lever upward to the Mist position and release for a single wiping
cycle.
NOTE:
The mist feature does not activate the washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash function must be used in order to spray the
windshield with washer fluid.
Rain Sensing Wipers — If Equipped
This feature senses moisture on the windshield and automatically activates the
wipers for the driver. The feature is especially useful for road splash or overspray from
the windshield washers of the vehicle ahead. Rotate the end of the multifunction
lever to one of the two detent positions for intermittent settings, to activate this
feature.
This function can be activated by the Uconnect Settings through the radio. Refer to
"Uconnect Settings" in the "Multimedia" in the Owner's Manual on the DVD for
further information.
The sensitivity of the system can be adjusted with the multifunction lever. Wiper
delay position one is the least sensitive, and wiper delay position two is the most
sensitive. Place the wiper switch in the OFF position when not using the system.
42
WARNING!
Advertisement
Table of Contents
