Mode Of Operation; Blind Spot Alert Lights Only; Blind Spot Alert Lights/Chime; Blind Spot Monitoring Fault Warnings - Jeep RENEGADE 2016 User Manual

Hide thumbs Also See for RENEGADE 2016:
Table of Contents

Advertisement

OPERATING YOUR VEHICLE

Mode Of Operation

Three selectable modes of operation are available in the Uconnect System. Refer to
"Uconnect Settings" in "Multimedia" in your Owner's Manual on the DVD for further
information.

Blind Spot Alert Lights Only

When operating in Blind Spot Alert mode, the BSM system will provide a visual alert
in the appropriate side view mirror based on a detected object. However, when the
system is operating in Rear Cross Path (RCP) mode, the system will respond with
both visual and audible alerts when a detected object is present. Whenever an
audible alert is requested, the radio is muted.

Blind Spot Alert Lights/Chime

When operating in Blind Spot Alert Lights/Chime mode, the BSM system will provide
a visual alert in the appropriate side view mirror based on a detected object. If the
turn signal is then activated, and it corresponds to an alert present on that side of the
vehicle, an audible chime will also be sounded. Whenever a turn signal and detected
object are present on the same side at the same time, both the visual and audible
alerts will be issued. In addition to the audible alert, the radio (if on) will also be
muted.
NOTE:
Whenever an audible alert is requested by the BSM system, the radio is also muted.
When the system is in RCP, the system will respond with both visual and audible
alerts when a detected object is present. Whenever an audible alert is requested, the
radio is also muted. Turn/hazard signal status is ignored; the RCP state always
requests the chime.
Blind Spot Alert Off
When the BSM system is turned off, there will be no visual or audible alerts from
either the BSM or RCP systems.
NOTE:
The BSM system will store the current operating mode when the vehicle is shut off.
Each time the vehicle is started the previously stored mode will be recalled and used.

Blind Spot Monitoring Fault Warnings

Sensor Blinded
In the case of a sensor blinded:
• BSM Mirror Warning Lights are turned on continuously.
• A instrument cluster dedicated message will display.
NOTE:
The rear bumper must be clean and free of any obstructing debris.
55

Advertisement

Table of Contents
loading

Table of Contents