Table of Contents
Advertisement
The Automatic High Beam Headlight Control can
be turned on or off by selecting "ON" under
"Auto High Beam" within your Uconnect
Settings, as well as turning the headlight
switch to the AUTO position and placing the
multifunction lever in the high beam position.
A
H
UTOMATIC
EADLIGHTS
With the engine running, make sure your
headlight control knob is in the AUTO position;
your vehicle will detect how bright it is outside
and turn the headlights on/off as necessary.
WINDSHIELD WIPERS &
WASHERS
The windshield wiper/washer controls are
located on the windshield wiper/washer lever on
the right side of the steering column. The front
wipers are operated by rotating a switch, located
on the end of the lever.
INTERIOR
30
Windshield Wiper/Washer Lever
W
W
O
INDSHIELD
IPER
PERATION
Front Wipers
Rotate the end of the lever upward to the first
detent past the intermittent settings for low-
speed wiper operation.
Rotate the end of the lever upward to the
second detent past the intermittent settings for
high-speed wiper operation.
Windshield Washers
To use the washer, pull the windshield wiper
lever toward the steering wheel and hold.
Mist
Push the lever upward to the MIST position and
release for a single wiping cycle.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The washer function must
be used in order to spray the windshield with
washer fluid.
WARNING!
Sudden loss of visibility through the windshield
could lead to a collision. You might not see
other vehicles or other obstacles. To avoid
sudden icing of the windshield during freezing
weather, warm the windshield with the defroster
before and during windshield washer use.
CAUTION!
●
Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the parked position. If the
windshield wiper switch is turned off, and
the blades cannot return to the parked
position, damage to the wiper motor may
occur.
●
In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine.
If the wiper switch is left on and the wipers
freeze to the windshield, damage to the
wiper motor may occur when the vehicle is
restarted.
Advertisement
Table of Contents
