Table of Contents
Advertisement
4.4. Basic Installation
4.4.1.
Mounting and Wiring
Follow the steps below for mounting and wiring the camera.
1.
Before screwing the camera to the wall, drill four holes on the wall according to the hole-positions
on the supplied Quick-Mounting Ring. If you wish to run the wires into the wall, drill another hole
in the middle of the circular area within the Quick-Mounting Ring.
Circular Area
2.
Push the four supplied Anchors into the four holes on the wall. Place the Quick-Mounting Ring
against the anchoring surface so that the holes line up. Screw the Quick-Mounting Ring to the
wall using the supplied Long Screws.
Quick-Mounting Ring
Long Screws
3.
Screw the camera base to the Quick-Mounting Ring using the supplied four Short Screws.
This conduit Is for wiring the cables along
the wall installation.
Anchors
Wall
6
Plug
If you want to wire the cables through the wall,
then this conduit will not be used. You can
insert the supplied Plug into the conduit.
Camera Base
Short Screws
Short Screws
EZN7221/7260/7360
Quick-Mounting Ring
Advertisement
Table of Contents
