Table of Contents
Advertisement
providing compatibility among networked devices listed in the networked device table. Enable the
UPnP function means you can directly connect the cameras listed in the networked device table by
clicking on them.
Note:
1. For the UPnP function to work, an UPnP-enabled router is required.
2. The UPnP function may fail owing to the compatibility between the camera and the router.
【Multicast Settings】This function can only be set up in the Advanced tab. Enable if required, fill in
the setting options and click Apply to save. For more details, please refer to
Multicast
Function.
Enable Multicast: Check the box to enable the Multicast function.
Multicast IP: Fill in the multicast IP address. IP addresses in the range of 224.0.0.0 through
239.255.255.255 are reserved for multicasting. For devices, you can use 225.x.x.x - 232.x.x.x and
234.x.x.x - 238.x.x.x. Click
Port: Change the port number if necessary. The port number has set to 50000 by default.
Time to Live: Input a Time-To-Live (TTL) value. The TTL value specifies the number of routers (hops)
that multicast traffic is permitted to pass through before expiring on the network.
【DDNS Settings】 This function can only be set up in the Advanced tab. DDNS (Dynamic Domain Name
System) is a service used to map a domain name to the dynamic IP address of a network device. You
can set up the DDNS service for remote access to the IP camera. DDNS assigns a domain name (URL)
to the IP camera, so that the user does not need to go through the trouble of checking if the IP
address assigned by DHCP Server has changed. Once the IP is changed, the IP camera will
automatically update the information to the DDNS to ensure it is always available for remote access.
For setting up the DDNS function, please refer to
Before enabling the following DDNS function, user should have applied for a host name from the
DDS service provider's website. We support these four DDNS server providers:
www.everfocusddns.com, www.sitelutions.com, www.dyndns.com, and www.no-ip.com
Note: We highly recommend that you use xxxx.everfocusddns.com for the simplicity of setting up
your IP cameras.
Enable Service ISP: Check this box to enable the DDNS function. You can either apply for a host
name from EverFocus or other DDNS server providers.
From EverFocus: If you choose the EverFocus DDNS server, you can obtain a free host name
•
from EverFocus. To obtain a free host name from EverFocus, type a desired host name in
the textbox, click the Register / Update button, and then click the Apply button.
From other DDNS server providers: To obtain a domain name from one of the three DDNS
•
here
for more details.
31
Appendix E. Setting up DDNS
EZN7221/7260/7360
Appendix B. Enabling the
Function.
Advertisement
Table of Contents
