Buell 2005 P3 Service Manual page 367

HOME
REMOVAL
1. Remove seat. See 2.28
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative battery cable from battery terminal.
3. Remove four screws and washers to detach windscreen
from mounting brackets. See
a0284x7x
Figure 7-14. Ignition Key Switch Connector [33]
Table 7-13. Ignition Switch Connector [33]
[33] WIRE
A Master circuit breaker
B Accessories fuse in fuse block
C Ignition fuse in fuse block
D Empty
4. See Figure 7-14. Cut cable tie and disconnect ignition
key switch connector [33] from main wiring harness.
Note location of cable tie.
5. Remove two headlight bucket bolts and headlamp
bucket. See 7.17 HEADLAMP.
6. Remove two bolts and ignition key switch.
SEAT.
WARNING
2.26 WINDSCREEN.
TERMINATION
INSTALLATION
1. Apply LOCTITE 243 (Blue) to threads of two ignition key
switch bolts.
2. Install ignition key switch into hole and secure with two
bolts. Tighten bolts to 48-72 in-lbs (5-8 Nm).
3. See Figure 7-14. Attach ignition key switch connector
[33] to main wiring harness. Secure harness with cable
tie.
4. Install headlight bucket with two bolts. Tighten bolts to
12-14 ft-lbs (16-19 Nm).
5. Cable tie ignition key switch connector [33] to main wiring
harness.
6. Install four screws and washers to attach windscreen to
mounting brackets. See
7. Install negative battery cable to battery terminal. Tighten
fastener to 60-96 in-lbs (6.8-10.8 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
8. Install seat. See 2.28 SEAT.
11 1
WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
9. Check ignition key switch for proper operation. If opera-
tion fails, reread procedure and verify that all steps were
performed.
a. Turn ignition key switch to OFF. Check all functions
listed in Table 7-11.
b. Turn ignition key switch to IGN. Start motorcycle.
See Section 4.
c. Turn ignition key switch to LOCK.
2005 Buell P3: Electrical
2.26 WINDSCREEN.
WARNING
WARNING
7-15