Buell 2005 P3 Service Manual page 132

HOME
7704
1
3
3
1. Banjo bolt (metric)
2. Screw (2) (metric)
3. Spacers
4. Rubber boot
5. Rod adjuster
6. Locknut
7. Clevis
Figure 2-47. Master Cylinder Mounting
4. See Figure 2-47. Remove two screws (2) and spacers
(3) to detach master cylinder from footrest support.
7703
Figure 2-48. Remote Reservoir
5. See Figure 2-48. Detach remote reservoir.
2
2
4
5
6
7
DISASSEMBLY
NOTE
Do not disassemble master cylinder unless problems are
experienced. Discard all seals during the disassembly proce-
dure. Install a complete rebuild kit upon assembly.
6506a
1. Master cylinder body
2. Snap ring
3. Rod assembly
4. Piston assembly
Figure 2-49. Master Cylinder Internals
1. See Figure 2-49. Slide rubber boot on rod assembly (3)
away from master cylinder body (1).
2. Depress rod assembly (3) and remove internal snap ring
(2). Discard snap ring.
3. Remove piston assembly (4) from master cylinder body.
1
2
4
3
2005 Buell P3: Chassis 2-33