Diagnostic Charts - Buell 2005 P3 Service Manual

HOME

DIAGNOSTIC CHARTS

No Spark at Spark Plug
•Ignition On.
•Multimeter Red Wire To White/Black Wire On
Coil Connector [83], Multimeter Black Wire To
Ground.
1
•Meter Should Register 12v ± One Volt.
YES
Go To Next Page
1
Use harness connector
adaptor kit (HD-41404)
gray male probe and
patch cord.
NOTE
Male connectors are labeled "A"
Female connectors are labeled "B"
No. Description
[22] RT Handlebar Switch
7-6 2005 Buell P3: Electrical
NO
Check Ignition Fuse
Is Fuse Ok?
YES
Battery Voltage at Gray
Wire In Fuse block?
YES
Measure Voltage At Connector [22A]
Pin 4 (GY).
Battery Voltage Present?
YES
With Connector [22] Mated And Ignition On,
Measure Voltage At Connector [22A], Pins 2
and 3 (W/BK).
Battery Voltage Present?
YES
Repair Open (W/BK) Wire Between
Coil and [22A].
Wire Harness Connectors
Type
4 - Place Multilock
Figure 7-4. No Spark At Spark Plug
W/BK
W/BK
PK
NO
Replace - Find Source Of Fault
NO
Check For 12VDC Between Battery,
Main Breaker, Ignition Switch And
Fuse Block.
Repair As Necessary.
NO
Repair Open (GY) Wire Between [22]
and Fuse.
NO
Repair / Replace Engine Stop Switch
or Wiring.
5002
Location
Behind Headlight
7.3
+
-
PK
5001
5001
5002
5173