Idle Speed Adjustment - Buell 2005 P3 Service Manual

HOME

IDLE SPEED ADJUSTMENT

NOTE
The Blast P3 is equipped with an auto-enrichener that auto-
matically increases the idle speed and richens the fuel mix-
ture at startup. To correctly set the idle speed, the auto-
enrichment cycle must be complete (idle speed has slowed
from startup).
Check idle speed adjustment after the bike is warmed up.
See Figure 1-43. Regular idle speed is 1200 RPM. Set idle
speed using remote idle adjustment screw.
1. Perform dealer road test first.
NOTE:
Be sure the engine is warmed up to normal operating temper-
ature. Be aware that because there are variations in individ-
ual components, it is possible for a properly warmed-up
engine to idle at 2000 RPM.
2. See Figure 1-44. The ignition coil cable is located on the
left side of the bike behind the fuel supply valve. With the
bike running, place hand held tachometer on ignition coil
cable.
3. Press the tachometer button to obtain a reading for the
current RPM.
4. See Figure 1-43. Set engine speed by turning the idle
adjuster clockwise to increase speed or counter clock-
wise to decrease speed until the tachometer has a read-
ing of 1200 RPM.
5. Turn the ignition switch to off position.
1-38 2005 Buell P3: Maintenance
a0034xSx
Figure 1-43. Adjusting Idle Speed using Idle
Adjustment Screw
a0033xSx
2
1
1. Ignition coil cable
2. Fuel supply valve
3. Tachometer button
Figure 1-44. Checking RPM Using a Hand Held
Tachometer
3