Buell 2005 P3 Service Manual page 197

HOME
a0162x6x
7
6
5
4
1. Frame
2. Locknut
3. Snubber
4. Bolt
5. Spacer
6. Front isolator
7. Standoff
Figure 3-41. Front Isolator Mount
32. See Figure 3-41. Install front isolator mounting bolt,
spacer snubber and new nut.
33. Tighten front isolator mounting bolt to 63-70 ft-lbs (86-95
Nm).
7629
Figure 3-42. Install Crankcase Breather Hose
34. See Figure 3-42. Install crankcase breather hose and
crankcase breather into rocker box grommet.
35. Install horn. See 7.22 HORN.
36. Remove jack from under the motor.
37. Install muffler. See 2.20 EXHAUST
38. Install fuel tank. See
TANK.
39. Install new oil filter, engine oil and primary chaincase
fluid as necessary.
1
3 2
SYSTEM.
4.2 FUEL TANK COVER/FUEL
a0016x3x
1
2
3
4
5
6
1. Frame
2. Locknut
3. Washer
4. Spacer
5. Footrest support bracket
6. Clevis pin
7. Footpeg
8. Cotter pin
9. Index plate
10. Spacer
Figure 3-43. Footpeg Bracket Assembly
40. See Figure 3-43. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
11 1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
41. Connect both battery cables, positive cable first. See
7.16 BATTERY.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
42. Install seat. See 2.28 SEAT.
10
9
8
7
WARNING
WARNING
2005 Buell P3: Engine 3-23