Buell 2005 P3 Service Manual page 361

HOME
Is bank angle sensor connected?
Measure voltage on [134B] between socket A, LT GN/GY and socket B, BK
3.0-3.5 VDC
See next page
Bank Angle Sensor
Connector [134]
YES
Reconnect.
Disconnect connector [134].
11-13 VDC
Repair short on
LT GN/GY wire.
5007
8261
Figure 7-7. Continuous or No Spark At Spark Plug
NO
*
To avoid damage to terminals, remove Bank
Angle Sensor before disconnecting connector [134].
Use HARNESS CONNECTOR ADAPTER KIT
HD-41404,Gray male probe and patch cord
0 VDC
Disconnect connector [10]. Check continuity between socket A, LT GN/GY on
connector [134B] and socket 5, LT GN/GY on connector [10B].
Continuity present?
YES
Check continuity to ground on TN/Y wire, socket B,
connector [134B].
Is continuity present?
YES
Check continuity to ground on LT GN/GY wire, socket A,
connector [134B] or [10B].
Is continuity present?
YES
Repair short to ground on LT
GN/GY wire.
NO
Repair open in
LT GN/GY wire.
5007
NO
Check starter
interlock.
5007
NO
Inspect module harness
for damage.
Repair if necessary.
5007
If harness is not damaged,
replace ignition module.
2005 Buell P3: Electrical 7-9