Buell 2005 P3 Service Manual page 150

HOME
3781
Figure 2-87. Slider Tube Protection
11. See Figure 2-87. Wrap the end of the slide pipe and the
slide bushing channel with tape to avoid damaging the oil
seal lip when installing.
12. Coat dust seal, oil seal spacer, and backup ring with fork
oil or sealing grease.
3785
Figure 2-88. Oil Seal and Backup Ring
13. See Figure 2-88. Install oil seal spacer and backup ring.
3787
Figure 2-89. Fork Seal Driver
14. See Figure 2-89. Using FORK SEAL DRIVER (Part No.
B-43991), drive the guide bushing with the oil seal
spacer and oil seal into position in the slider assembly.
3786
1
1. Retaining ring
2. Groove
Figure 2-90. Install New Retaining Ring
15. See Figure 2-90. Install retaining ring. Verify ring is
installed securely in the groove inside slider assembly.
2
2005 Buell P3: Chassis 2-51