Buell 2005 P3 Service Manual page 314

HOME
REMOVAL
Primary Cover
1. Remove seat. See 2.28
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
11 1
WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Disconnect negative battery cable from battery.
3. See Figure 6-1. Place a drain pan under the engine.
Remove drain plug and drain lubricant from primary
drive.
4. Remove shifter lever assembly and rubber washer. Do
not scratch primary cover.
5. See ADJUSTMENT under
to clutch cable.
7668
3
1. Primary cover
2. Locknut
3. Chain limiting screw
4. Chain guide
Figure 6-2. Removing Primary Chain Adjuster
6. See Figure 6-2. Loosen locknut. Turn chain adjuster
screw counterclockwise (outward).
7. Remove left foot peg support bracket. See
PEGS AND FOOTPEG SUPPORT
8. Remove three sems screws with washers and clutch
inspection cover.
9. Remove and discard gasket from groove in primary
cover.
10. Slide spring with attached hex lockplate from flats of
clutch limiting screw.
6-4 2005 Buell P3: Drive/Transmission
SEAT.
WARNING
WARNING
1.10 CLUTCH. Add freeplay
4
1
2
2.21 FOOT-
BRACKETS.
a0110x6x
1
2
3
4
5
6
1. Primary cover
2. Chain adjusting nut
3. Chain limiting screw
4. Shoe
5. Spring
6. Pin
Figure 6-3. Primary Chain Adjuster
11. See Figure 6-3. Turn clutch adjusting screw clockwise to
release ramp and coupling mechanism. As the limiting
screw is turned, ramp assembly moves forward. Unscrew
nut from end of limiting screw.
12. Remove hook of ramp from button to the rear of cable
end coupling. Remove cable end from slot in coupling.
Remove coupling and ramp assembly.
13. Remove screws which secure primary cover. Remove
cover and gasket.
14. Discard gasket.
15. Remove and discard shifter lever oil seal.
Primary Chain Adjuster
1. Loosen locknut from chain limiting screw. Turn limiting
screw out of threaded boss in primary cover.
2. See Figure 6-2. Remove primary cover.
3. See Figure 6-3. Slide shoe outward and remove.
4. Remove chain tensioner spring.