Ipcf; Show Wlan Ipcf - Siemens SCALANCE W760 Configuration Manual

Result
The recording is configured and will be started. The measured values are output in the CLI
and logged in files. If these files already exist, they will be overwritten. If the set total number
of measured values is reached, the recording stops automatically.
Use the
During the recording, it is possible that working in the CLI becomes slower.
Further notes
You stop the recording early with the
You display the status of the signal recorder and the recording with the
recorder <wlan 0/X>
4.3

iPCF

This section describes the commands relevant for working with the iPCF function (industrial
Point Coordination Function).
Note
The commands are only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
4.3.1

show wlan ipcf

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
This command shows the settings of iPCF.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
wlan signal-recorder <wlan 0/X> stop
command.
Functions specific to SCALANCE
command to stop the recording early.
wlan signal-recorder <wlan 0/X> stop
4.3 iPCF
command.
show wlan signal-
91