No Wlan Security Dot1X Check-Server-Certificate (Client) - Siemens SCALANCE W760 Configuration Manual

10.2.5.5

no wlan security dot1x check-server-certificate (client)

Description
With this command, you disable the validation of the server certificate on the client. This
setting is activated as default.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan security dot1x check-server-certificate
Result
Validation is disabled.
Further notes
You display the settings with the
You enable the validation with the
command.
See also
wlan security dot1x check-server-certificate (client) (Page 378)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show wlan security <wlan 0/X>
wlan security dot1x check-server-certificate
Security and authentication
10.2 WLAN
command.
379