Siemens SCALANCE W760 Configuration Manual page 401

Parameter
a,b or a-b or
a,b,c-d
service
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The IP address 0.0.0.0 means "any manager"
If optional parameters are not specified when configuring, the following defaults apply:
● The manager is authorized for all services.
Note
Configuration of the first entry
As long as the list of authorized managers is empty, access to the system is not
restricted.
As soon as the list contains an entry, access to the system is blocked for all others.
You should therefore configure the interface via which you access the system first
because your access is otherwise blocked.
Result
The interfaces and protocols via which an authorized manager is allowed to access the
device are configured.
Further notes
You delete an interface for access of an authorized manager with the
ip-source
You show the information about the configuration of the authorized managers with the
authorized-manager
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Number of a VLAN or VLAN range
Specifies the services for which the manager is
authorized.
You can select several options.
command.
command.
Security and authentication
10.3 Management Access Control List
Range of values
enter a valid VLAN or VLAN
range
•
snmp
•
telnet
•
http
•
https
•
ssh
no authorized-manager
show
401