Link - Siemens SCALANCE W760 Configuration Manual

Diagnostics
11.1 Diagnostics
Syntax
Call up the command with the following parameters:
no severity { mail | log | syslog }
The parameters have the following meaning:
Parameter
mail
log
syslog
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for sending system event messages are configured.
Further notes
You enable the setting with the
You display the status of this function and other information
11.1.14.8

link

Description
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
420
Description
The setting of the threshold value for
sending system event messages by e-
mail is disabled.
The setting of the threshold value for
entering system event messages in the
log table disabled.
The setting of the threshold value the
entering event messages in the Syslog
file is disabled.
command.
severity
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
-
-
show events severity
Configuration Manual, 11/2014, C79000-G8976-C351-03
.