Siemens SCALANCE W760 Configuration Manual page 416

Diagnostics
11.1 Diagnostics
Parameter
stp-change
overlap-ap
wds
dfs
wlan-general
wlan-auth-log
ipcf-cycle-time
ipcf-poll-size
all
logtable
syslog
email
trap
faults
all
Result
The setting deciding which message of the device is stored or forwarded is configured.
Further notes
You display the status of the events and the clients with the
You delete the settings with the
With this command, the clients are not enabled.
To enable the clients, use the
Note
Changing several message types or clients
With each command call, you can only select one message type and one client.
If you want to process several message types or clients, it may be more efficient to first
select the
416
Description
Message when there is a change in the spanning tree
Message if radio channels overlap (in Access Point mode only)
Message if there are changes to WDS (in Access Point mode only)
Message if a radar signal is received or if there is a status change in the DFS scan
(only in Access Point mode)
Message if the channel bandwidth has changed (in Access Point mode only)
Message if changes are made to the log file (in Client mode only)
Message if too many clients are logged on for the set iPCF cycle time or if some cli-
ents were not reached in one cycle
(only in access point mode and only available if supported by the device)
Message when the PNIO data size is too large for the transmission.
(only available if supported by the device)
All messages
Client that processes the logbook entries
Client that sends the messages to the log server
Client that sends the e-mails
Client that sends the SNMP traps
The device triggers an error. The error LED lights up.
All clients at once
no event config
client config
option and then disable individual elements.
all
show events config
command.
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.