Commands In The Wlan Interface Configuration Mode - Siemens SCALANCE W760 Configuration Manual

Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator shared-secret <index(1-2)> <string>
The parameters have the following meaning:
Parameters
index
string
Result
The password is configured.
Further notes
You display the setting with the
See also
show wlan security ap-radius-authenticator (Access Point) (Page 361)
10.2.5

Commands in the WLAN Interface configuration mode

This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WLAN Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
the Privileged EXEC mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Index of the RADIUS server
Password
show wlan security ap-radius-authenticator
interface wlan 0/X
Security and authentication
10.2 WLAN
Values or range of values
1...2
Enter the password of the
RADIUS server.
command.
command to change to this
command, you return to
exit
command, you return to
end
373