Adjusting The Anti-Scalp Rollers - Toro 74933 Operator's Manual

Adjusting the Height-of-Cut Pin
You can adjust the height of cut to from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by locating the
clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inches) cutting-height position) as shown in
Figure 23.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
23).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 23
1. Deck-lift pedal
2. Cut-of-height pin
(Figure 23).
(Figure
3. Transport lock
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the
BLADE
the motion-control levers to the
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in
Figure 25, and Figure
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
25
- switch (PTO), move
CONTROL
-
NEUTRAL LOCK
Figure
26.
Figure 24
4. Flange nut
5. Bolt
Figure 25
3. Flange nut
4. Bolt
24,