Adjusting The Motion-Control Damper - Toro 74933 Operator's Manual

of the jumper wire being used. Run the engine at
throttle and release the brake.
FULL
6. Run the machine at least 5 minutes with the
motion-control levers at full
the hydraulic fluid up to operating temperature.
Note: The motion-control lever needs to be in
while making any necessary adjustments.
NEUTRAL
7. Bring the motion-control levers into the
position.
8. Adjust the pump-control rod lengths by rotating the
double nuts on the rod in the appropriate direction
until the wheels slightly creep in reverse
g027428
Figure 81
1. Double nuts
9. Move the motion-control levers to the
position, and while applying slight pressure to the lever,
allow the reverse-indicator springs to bring the levers
back to .
NEUTRAL
Note: The wheels must stop turning or slightly creep
in reverse.
10. Shut off the machine. Remove the jumper wire from
wire harness and plug the connector into the seat
switch.
11. Remove the jack stands.
12. Raise the deck and install the height-of-cut pin.
13. Check that the machine does not creep in
with the park brakes disengaged.
speed to bring
FORWARD
NEUTRAL
(Figure 81).
REVERSE
NEUTRAL
Adjusting the Motion-Control
Damper
The top damper-mounting bolt can be adjusted to obtain a
more desired motion-control lever resistance. See
for mounting options.
1. Insert the damper end into the desired position.
2. Torque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
Right motion control shown
1. Locknut
2. Most resistance
3. Damper
55
Figure 82
Figure 82
4. Medium resistance
5. Least resistance