Stopping The Machine; Adjusting The Height-Of-Cut - Toro 74933 Operator's Manual

Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control levers
rearward (Figure 21).
Figure 21

Stopping the Machine

To stop the machine, move the traction-control levers to
, and then move them to the locked position,
NEUTRAL
disengage the power take off blade-control switch (PTO), and
turn the ignition key to the O
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page
the switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
G008953
position.
FF
19). Remove the key from

Adjusting the Height-of-Cut

Using the Transport Lock
The transport lock has 2 positions and is used with the
deck-lift pedal. There is a lock position and an unlock
position for the transport position. You use the transport
lock with the deck-lift pedal
1
2
3
1. Transport lock
2. Lock position—mower deck will lock into the transport
position
3. Unlock position—does not lock the mower deck into the
transport position
24
(Figure 22).
g032377
Figure 22