Using The Rollover-Protection System (Rops) - Toro 74933 Operator's Manual

Using the Rollover-Protection
System (ROPS)
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.,
branches, doorways, electrical wires) before
driving under any objects, and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
Important: Ensure that the rear part of the seat is
secured with the seat latch.
1. To lower the roll bar, apply forward pressure to the
upper part of the roll bar.
2. Pull both knobs out and rotate them 90° so they are
not engaged (Figure
3. Lower the roll bar to the down position
9).
(Figure
2
1. ROPS knob
2. Pull ROPS knob out and
9).
rotate 90 degrees
4. To raise the roll bar, raise the roll bar to the operate
position, rotate the knobs so they move partially into
the grooves
5. Raise the roll bar to the full upright position while
pushing on the upper roll bar and the pins will snap
into position when the holes align with the pins
9). Push on the roll bar and ensure that both pins are
engaged.
Important: Always use the seat belt with the roll
bar in the fully raised position.
18
1
3
4
Figure 9
3. Roll bar in the upright
position
4. Roll bar in the folded
position
(Figure 9).
g021418
(Figure