Loading The Machine - Toro 74933 Operator's Manual

Figure 35
1. Tie-down loops

Loading the Machine

Use extreme caution when loading or unloading machines
onto a trailer or a truck. Use a full-width ramp that is wider
than the machine for this procedure. Back up ramps and
drive forward down ramps
Figure 36
1. Back up ramps
Important: Do not use narrow individual ramps for
each side of the machine.
Ensure the ramp is long enough so that the angle with the
ground does not exceed 15 degrees
ground, this requires a ramp to be at least 4 times as long as
the height of the trailer or truck bed to the ground. A steeper
angle may cause mower components to get caught as the unit
moves from the ramp to the trailer or truck. Steeper angles
may also cause the machine to tip or lose control. If you are
loading on or near a slope, position the trailer or truck so that
it is on the down side of the slope and the ramp extends up
the slope. This will minimize the ramp angle.
G027423
(Figure 36).
2. Drive forward down ramps
(Figure 37). On flat
WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Ensure that the ROPS is in the up position and
use the seat belt when loading or unloading the
machine. Ensure that the ROPS will clear the
top of an enclosed trailer.
• Use only a full-width ramp; do not use individual
ramps for each side of the machine.
• Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Ensure the length of ramp is at least 4 times as
long as the height of the trailer or truck bed to
the ground. This will ensure that ramp angle
does not exceed 15 degrees on flat ground.
• Back up ramps and drive forward down ramps.
• Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
g028043
30