Engine Maintenance; Servicing The Air Cleaner - Toro 74933 Operator's Manual

13. Apply a thread-locking adhesive to the second spacer
nut and thread it onto the axle with the wrench flats
facing outward.
14. Torque the nut to 8 to 9 N∙m (75 to 80 in-lb), loosen
the nut, then torque it to 2 to 3 N∙m (20 to 25 in-lb).
Note: Ensure that the axle does not extend beyond
either nut.
15. Install the seal guards over the wheel hub and insert
the wheel into the caster fork. Install the caster bolt
and tighten the nut fully.
Important: To prevent seal and bearing damage, check
the bearing adjustment often. Spin the caster tire. The
tire should not spin freely (more than 1 or 2 revolutions)
or have any side play. If the wheel spins freely, adjust the
torque on the spacer nut until there is a slight amount of
drag. Apply thread-locking adhesive.

Engine Maintenance

WARNING
Contact with hot surfaces may cause personal
injury.
Keep your hands, feet, face, clothing, and other
body parts away the muffler and other hot surfaces.

Servicing the Air Cleaner

Service Interval: Every 150 hours
Every 300 hours/Yearly (whichever comes
first)—Replace the primary air filter. (more often in
dusty or sandy conditions)
Every 300 hours—Check the air filter.
Every 600 hours—Replace the air filter.
Note: Check the filters more frequently if the operating
conditions are extremely dusty or sandy.
Removing the Filters
1. Disengage the PTO, move the motion-control levers to
the -
NEUTRAL LOCK
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Release the latches on the air cleaner and pull the
air-inlet cover off the air-cleaner body
4. Clean the air-inlet screen and cover.
5. Install the air-inlet cover and secure it with the latches
(Figure 43).
2
1
1. Air-inlet cover
2. Air-inlet screen
6. Release the latches on the air cleaner and pull the
air-cleaner cover off the air-cleaner body
7. Clean the inside of the air-cleaner cover with
compressed air.
36
position, and set the parking brake.
(Figure
3
4
Figure 43
3. Air-cleaner body
4. Latch
(Figure
43).
g012996
44).