Hour Meter; Fuel Gauge; Throttle Control; Ignition Switch - Toro 74933 Operator's Manual

Hour Meter

The hour meter records the number of hours the engine has
operated. It operates when the engine is running. Use these
times for scheduling regular maintenance

Fuel Gauge

Located on the LPG-fuel tank.
This gauge monitors the amount of liquid LPG in the fuel
tank.
Safety Pressure-Relief Valve
The relief valve is located on the LPG-fuel tank
The safety pressure-relief valve relieves the excess pressure
in the LPG tank.
Important: This valve has a protective-plastic cap
that should never be removed. If the cap is damaged
or missing, contact trained and qualified personnel
immediately.
LPG Cylinder Brackets
The brackets are located on the engine deck.
The LPG-cylinder brackets are used to fasten the removable
LPG tank to the mower.
Safety-Interlock Indicators
The symbols on the hour meter indicate with a black triangle
that the interlock component is in the correct position
6).

Throttle Control

The throttle control is variable between the F
positions.
Blade-Control Switch (PTO)
The blade-control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades,
push the blade-control switch (PTO) down or move a
motion-control lever into the

Ignition Switch

This switch is used to start the mower engine and has three
positions: S , R , and O
TART UN
Motion-Control Levers
The motion-control levers are used to drive the machine
forward, reverse, and turn either direction.
(Figure 5).
(Figure
(Figure
and S
AST LOW
- position.
NEUTRAL LOCK
.
FF
Neutral-Lock Position
The -
NEUTRAL LOCK
system to engage and to determine
Fuel-Shutoff Valve
Close the LPG-shutoff valve on the cylinder tank when
transporting or storing the mower.
Electronic Control Unit Malfunction
Indicator Light
The electronic-control unit (ECU) continuously monitors the
7). operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated.
The MIL is the red light located in the right console panel.
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Toubleshooting.
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
14
position is used with the safety-interlock
position.
NEUTRAL