Changing the password
1.
Open the OSD menu and go to the System Setup: Advanced > Security
Settings > Change password menu.
2.
Press MODE/ENTER. The message 'INPUT CURRENT PASSWORD' displays.
3.
Enter the old password.
•
If the password is correct, another message 'INPUT NEW PASSWORD'
displays.
•
If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for
your retry. You can press MENU/EXIT to cancel the change or try another
password.
4.
Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this manual in advance or right after the password is entered so that it is available to you
should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5.
Confirm the new password by re-entering the new password.
6.
You have successfully assigned a new password
to the projector. Remember to enter the new
password next time the projector is started.
7.
To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the System Setup: Advanced > Security
Settings > Change Security Settings menu after opening the OSD menu system. Press
MODE/ENTER. The message "INPUT PASSWORD" appears. Enter the current
password.
i. If the password is correct, the OSD menu returns to the Security Settings.
Press ▼ highlight Power On Lock and press ◄/► to select Off. You will not
have to enter the password next time you turn on the projector.
ii. If the password is incorrect, the password error message displays lasting for
three seconds, and the message 'INPUT PASSWORD' displays for your retry.
You can press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should you
ever need to re-activate the password function by entering the old password.
Operation
Password Changed
31