Brake Maintenance; Adjusting The Parking Brake - Toro 07390 Workman HDX-Auto Operator's Manual

Figure 78
1. Cap (coolant-reserve tank)
5. Disconnect the lower radiator hose and allow the
coolant to flow into a drain pan.
Note: When the coolant stops flowing, connect the
lower radiator hose.
6. Slowly fill the radiator with a 50/50 mixture of water
and permanent ethylene glycol anti–freeze
7. Top off the radiator and install the cap
8. Slowly fill the coolant-reserve tank until level reaches
the bottom of the filler neck
9. Install the cap on the coolant-reserve tank
10. Start the engine and operate it until it is warm.
11. Stop the engine, check the coolant level, and replenish
the coolant if required.
1
G021229
(Figure 77).
(Figure 78).
(Figure 78).

Brake Maintenance

Adjusting the Parking Brake

Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake lever
(Figure 79).
1. Parking-brake lever
2. Loosen the set screw securing the knob to the
parking-brake lever
1. Parking-brake lever
2. Knob
3. Rotate the knob
(45 to 50 lb) is required to actuate the lever.
4. Tighten the set screw when finished
Note: If you can no longer make a parking-brake
adjustment by adjusting parking-the brake lever, loosen
the handle to the middle of the adjustment and adjust
the cable at the rear, then repeat step 3.
5. Install the rubber grip onto the parking-brake lever
(Figure 79).
52
Figure 79
2. Grip
(Figure 80).
Figure 80
3. Set screw
(Figure 80) until a force of 20 to 22 kg
(Figure 80).