Connecting The Cvt Intake Duct (Tc And H Models Only) - Toro 07390 Workman HDX-Auto Operator's Manual

Figure 5
1. Battery cover
2. Remove the battery cover from the battery base
5).
3. Install the positive-battery cable (red) onto the positive
(+) terminal of the battery and secure the cable with
the bolts and nuts (Figure
Figure 6
1. Insulator boot
(positive-battery cable)
2. Negative-battery post
4. Slide the insulator boot over the positive terminal.
Note: The insulator boot is used to prevent a possible
short-to-ground from occurring.
5. Install the negative-battery cable (black) onto the
negative (–) terminal of the battery and secure the cable
with bolts and nuts.
6. Align the battery cover to the battery base
7. Squeeze the battery cover, align the tabs to the battery
base, and release the battery cover
(Figure
6).
3. Negative-battery cable
(Figure 5).
(Figure 5).
4
Connecting the CVT Intake
Duct (TC and H Models only)
No Parts Required
Procedure
Important: Remove the plastic bag covering the end of
the CVT duct before starting the engine of the machine.
The CVT kit 121-9853 and adapter kit 127-8750 is required
for this procedure.
1. Loosen the hose clamp securing the plastic bag at the
end of the CVT intake hose and remove the bag.
Note: Discard plastic bag.
2. Raise the cargo box by performing the following:
A. Set the parking brake; refer to
(page 16).
B. Start the engine; refer to
27).
C. Move the hydraulic-lift lever backward to raise the
cargo box; refer to
D. Shut off the engine; refer to
(page 27).
E. Remove the bed support from the storage brackets
on back of the ROPS panel and install the support
onto the cylinder rod of the bed lift cylinder; refer
to Using the Bed Safety Support (page
3. Align the CVT intake hose onto the intake-tube
connector at the back side of the ROPS panel and
tighten the hose clamp
1. CVT intake hose
2. Hose clamp
14
Parking Brake
Starting the Engine (page
Hydraulic Lift Lever (page
Stopping the Engine
36).
(Figure 7).
Figure 7
3. Intake-tube connector
16).