Storage - Toro 07390 Workman HDX-Auto Operator's Manual

Figure 94
1. Jumper hoses
5. Keep all bystanders away from the vehicles.
6. Start the second vehicle and move the lift lever to the
raise position which will raise the disabled box.
7. Move the hydraulic lift lever to the neutral position and
set the hydraulic-lift lock; refer to
(page 16).
8. Install the bed safety support onto the extended lift
cylinder; refer to Using the Bed Safety Support (page
36).
Note: With both the vehicles turned off, move the lift
lever back and forth to remove the system pressure and
ease the disconnection of the quick couplers.
9. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both vehicles.
Important: Check the hydraulic fluid levels in
both vehicles before resuming operation.

Storage

Hydraulic Lift Lever
59
1. Position the machine on a level surface, set the parking
brake, stop the engine, and remove the ignition key.
2. Clean dirt and grime from the entire machine, including
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not use high-pressure
water to wash the machine. Pressure washing
the machine may damage the electrical system
or wash away necessary grease at friction points.
Avoid excessive use of water, especially near the
control panel, lights, engine, and battery.
3. Inspect the brakes; refer to
(page 24).
4. Service the air cleaner; refer to
(page 40).
5. Grease the machine.
6. Change the engine oil; refer to
Oil and Filter (page
7. Check the tire pressure; refer to
Pressure (page 26).
8. For storage over 30 days, prepare the fuel system as
follows:
A. Add a petroleum based stabilizer/conditioner to
the fuel in the tank.
Follow mixing instructions from the stabilizer
manufacturer. (1 oz per US gallon). Do not use
an alcohol based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and the
stabilizer/conditioner is used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Stop the engine, allow it to cool, and drain the
fuel tank.
D. Start the engine and run it until it stops.
E. Start and run the engine again until it will not
start again.
F. Dispose of drained fuel properly. Recycle as per
local codes.
Important: Do not store
stabilizer/conditioned gasoline for over
90 days.
9. Remove the spark plugs and check their condition;
refer to Replacing the Spark Plug (page
10. With the spark plugs removed from the engine, pour 2
tablespoons of engine oil into the spark plug hole.
11. Use the starter to crank the engine and distribute the
oil inside the cylinder.
Checking the Brake Fluid
Servicing the Air Filter
Changing the Engine
41).
Checking the Tire
42).