Raising The Box In An Emergency - Toro 07390 Workman HDX-Auto Operator's Manual

7. Remove the siphoning equipment from the reservoir
(Figure 91).
8. Add 7.5 L (2 US gallons)—Non-TC model or 15.1 L
(4 US gallons)—Non-TC model with the High Flow
Hydraulic Kit (option) or TC model of the specified
hydraulic fluid into the hydraulic reservoir
Important: Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
9. Install the dipstick and cap to the filler neck of the
hydraulic reservoir
10. Start the engine and operate the vehicle to fill the
hydraulic system. Check the hydraulic oil level and
replenish it, if required.
Raising the Box in an
Emergency
You can raise the box in an emergency without starting the
engine by cranking starter or by jumping hydraulic system.
Raising the Box Using the Starter
Note: If the engine will not crank, you must remove the load
and box (attachment) in order to service the engine.
1. Ensure that the transmission lever is in the P (park)
position; refer to Transmission Lever (page
2. Crank the starter while holding the lift lever in the
Raise position.
Note: Run the starter for 15 seconds then wait 60
seconds before engaging the starter again.
Raising the Box by Jumping the
Hydraulic System
Note: This procedure requires 2 hydraulic hoses, each with
a male and a female quick coupler, that fits the couplers on
the vehicle.
1. Back another vehicle up to the rear of the disabled
vehicle.
Important: The hydraulic system uses Mobil
M15. To avoid system contamination, make sure
that the vehicle you use to jump the hydraulic
system uses an equivalent fluid.
2. On both vehicles, disconnect the 2 quick coupler hoses
from the hoses secured to the coupler bracket
92).
(Figure
(Figure 91).
15).
91).
1. Quick coupler hose A
2. Quick coupler hose B
3. On the disabled vehicle, connect the 2 jumper hoses to
the hoses that were disconnected
Note: Cap the unused fittings.
1. Disconnected hoses
4. On the other vehicle, connect the 2 hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler)
Note: Cap the unused fittings.
(Figure
58
Figure 92
(Figure 93).
Figure 93
2. Jumper hoses
(Figure 94).