Checking The Fluid Levels - Toro 07390 Workman HDX-Auto Operator's Manual

1. Cargo-box lever
Lowering the Box
WARNING
The weight of the box may be heavy. Hands or
other body parts could be crushed.
Keep hands and other body parts clear when
lowering the box.
1. Ensure that the parking brake is set; refer to
Brake (page 16).
2. If the bed support is installed, remove the it; refer to
Using the Bed Safety Support (page
3. Start the engine; refer to
4. Move the lever forward to lower the cargo box
18).
Opening the Tailgate
1. Ensure that the cargo box is down and latched.
2. Open the latches on the left and right side of the cargo
box (Figure 19) and lower the tailgate.
Figure 18
36).
Starting the Engine (page
1. Latch handle
2. Latch gate

Checking the Fluid Levels

Parking
Preparing to Check the Fluid Levels
1. Move the machine to a level surface.
27).
2. Shift the transmission to the Park position, shut off
(Figure
the engine, set the parking brake, and remove the key
from the ignition switch.
3. Allow the machine to cool before you check the fluid
levels of the machine.
4. Check the following:
Note: Checking the engine oil, hydraulic fluid level, or
coolant level requires raising and lowering the cargo
box of the machine; refer to
(page
•
•
•
•
20
Figure 19
3. Latch pin
Operating the Cargo Box
19).
Checking the Engine-oil Level (page 21)
Checking the Hydraulic Fluid (page 22)
(page )
Checking the Brake Fluid (page 24)