Parking Brake - Toro 07390 Workman HDX-Auto Operator's Manual

1. Transmission lever
2. P (park)
3. R (reverse)

Parking Brake

Whenever the engine is shut off, set the parking brake
10) to prevent accidental movement of the vehicle.
•
To set the parking brake, pull back on the parking-brake
lever.
•
To release the parking brake, push the lever forward.
Note: Release the parking brake before moving the
vehicle.
•
If you park the vehicle on a steep uphill or downhill grade,
shift the transmission into P (park) and set the parking
brake. Place chocks at the downhill side of the wheels.
Figure 10
1. Parking-brake lever
Figure 9
4. N (neutral)
5. L (low forward)
6. D (drive)
Hydraulic Lift Lever
The hydraulic lift raises and lowers the bed. Move the
hydraulic lift lever rearward to raise the bed, and forward to
lower it (Figure
Important: When lowering the bed, hold the lever in the
forward position for 1 or 2 seconds after the bed contacts
the frame to secure it in the lowered position. Do not
hold the hydraulic lift in either the raise or lower position
for more than 5 seconds once the cylinders have reached
the end of their travel.
(Figure
1. Lower the bed
2. Raise the bed
3. Locked
Hydraulic-lift Lock
The hydraulic-lift lock locks the lift lever so that the hydraulic
cylinders do not operate when the vehicle is not equipped
with a bed (Figure
position when using the hydraulics for attachments.
Speed-range Lever
Use the speed-range lever
the 4 work-speed ranges for precise control of the
maximum-ground speed or a transport-speed range that is for
moving the machine between job sites.
16
11).
Figure 11
4. Unlocked
5. Hydraulic-lift lock
6. Hydraulic-lift lever
11). It also locks the lift lever in the On
(Figure 12) to select 1 of