MAINTENANCE WORK ON FRAME AND ENGINE
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is broken or worn:
–
Replace the wheel bearing.
–
Grease and mount the left and right spacers and the shaft seal rings.
Long-life grease (
–
Clean screw
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
700641-01
–
Position the brake calipers and check that the brake linings are seated correctly.
–
Mount screws
–
Operate the hand brake lever repeatedly until the brake lining presses up against the
brake disc and there is a pressure point. Fix the hand brake lever in its engaged posi-
tion.
The brake calipers straighten.
–
Tighten screws
700639-11
x
p. 192)
and wheel spindle
.
.
on both brake calipers but do not tighten yet.
on both brake calipers.
M24x1.5
45 Nm
(33.2 lbf ft)
89