MAINTENANCE WORK ON FRAME AND ENGINE
–
Remove the radiator cap and pour in coolant until it emerges without bubbles at the
vent hole, and then immediately mount and tighten the bleeder screw
Alternative 1
Coolant (
Alternative 2
Coolant (mixed ready to use) (
–
Fill the radiator completely with coolant. Mount the radiator cap.
–
Lean the vehicle on the side stand.
700630-10
–
Check the coolant level in the compensating tank. (
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
–
Start the engine and run it until it reaches operating temperature.
Six bars of the temperature display light up.
–
Stop the engine and allow it to cool down.
–
When the engine is cool, check the coolant level in the radiator and add coolant if nec-
essary.
–
Check the coolant level in the compensating tank. (
–
Position the fuel tank. (
p. 187)
p. 187)
p. 137)
.
p. 131)
p. 131)
135