Mercedes-Benz E-Class Operator's Manual page 299

Pull plug 4 with the cable and hose
#
of the tire inflation compressor housing.
Push the plug of hose 5 into flange
#
tire sealant bottle 1, until the plug engages.
Place tire sealant bottle 1
#
into recess 2 of the tire inflation compres‐
sor.
Remove the cap from valve
#
tire.
Screw filling hose
#
Insert plug
#
vehicle.
5 out
Switch on the ignition.
#
Press on and off switch
#
6 of
tion compressor.
The tire inflation compressor is switched on.
The tire is inflated. First, tire sealant is pum‐
head downwards
ped into the tire. The pressure may briefly
rise to approximately 500 kPa (5 bar/73 psi).
7 on the faulty
8 onto valve 7.
4 into a 12 V socket in your
3 on the tire infla‐
Breakdown assistance 297
Do not switch off the tire inflation compres‐
sor during this phase.
Let the tire inflation compressor run for a
#
maximum of ten minutes.
The tire should then have attained a tire
pressure of at least 200 kPa (2.0 bar/
29 psi).
If tire sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera‐
ble to use clean water.
If you get tire sealant on your clothing, have it
cleaned as soon as possible with perchloroethy‐
lene.
If, after ten minutes, a tire pressure of
200 kPa (2.0 bar/29 psi) has not been ach‐
ieved:
Switch off the tire inflation compressor.
#
Unscrew the filler hose from the valve of the
#
faulty tire.
Please note that tire sealant may leak out when
unscrewing the filling hose.