Synchronizing The Rolling Code - Mercedes-Benz E-Class Operator's Manual

142 Driving and parking
garage door can become trapped or struck
by the garage door.
When using the integrated garage door
#
opener, always make sure that nobody
is within the sweep of the garage door.
Only operate the garage door opener on the fol‐
lowing garage doors:
Garage doors with a safety stop and revers‐
R
ing feature.
Garage doors which conform to the current
R
U.S. safety standards.
When programming a garage door opener, park
the vehicle outside the garage.
Check if the transmitter frequency of the
#
remote control has the frequency range of
280 to 868 MHz.
Press and hold buttons 1,
#
Indicator lamp 4 flashes yellow.
% It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
Point remote control
#
(1 cm) to 3 in (8 cm) towards buttons 1,
or 3.
Press and hold button
#
5.
Indicator lamp
R
gramming is finished.
Indicator lamp
R
gramming has been successful. Addition‐
ally, synchronization of the rolling code
must also take place.
Indicator lamp
R
ing up green or flashing: repeat the pro‐
cedure.
Release button
#
% The remote control for the garage door drive
2 or 3.
is not included in the scope of delivery of the
garage door opener.

Synchronizing the rolling code

Prerequisites
The garage door system uses a rolling code.
R
4 continues to flash yellow.
5 at a distance of 1 in
2
6 of remote control
4 lights up green: pro‐
4 flashes green: pro‐
4 goes out, without light‐
6 on remote control 5.