Resolving Problems When Programming The Remote Control - Mercedes-Benz E-Class Operator's Manual

The vehicle must be within range of the
R
garage door or exterior gate drive.
The vehicle as well as persons and objects,
R
are located outside the sweep of the garage
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press programmed button :,
#
repeatedly, until the door closes.
% Please also read the operating instructions
for the garage door drive.
Resolving problems when programming the
remote control
Check if the transmitter frequency of remote
#
control : is supported.
Replace the batteries in remote control :.
#
Hold remote control
#
distance between 1 in (1 cm) to 3 in (8 cm)
in front of the inside mirror. You should test
every position for at least 25 seconds before
trying another position.
; or =
Hold remote control
#
at various distances in front of inside mirror.
You should test every position for at least
25 seconds before trying another position.
Note that some remote controls transmit
#
only for a limited period, press button
remote control
ends.
Align the antenna line of the garage door
#
opener unit with the remote control.
% Support and additional information on pro‐
gramming:
On the toll free HomeLink
R
1-800-355-3515.
On the Internet at http://
R
www.homelink.com
Opening/closing the garage door
Driving and parking 143
: at various angles at a
: at the same angles
; on
: again before transmission
®
Hotline on