EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
REMOVAL AND REPLACEMENT OF PARTS
FRONT CONTROL PANEL
electrical power to the machine and
follow lockout / tagout procedures.
1.
Pull out grease tray (1, Fig. 1) on models with
griddle.
2.
Remove 4 screws (2, Fig. 1) from control panel.
NOTE: Control panel is hinged and will rotate down.
Fig. 1
3.
Reverse procedure to install.
OVEN CONTROL PANEL
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove plug from the access hole in the oven
control panel.
F45586 (0716)
Disconnect the
Disconnect the
Page 6 of 33
Fig. 2
2.
Remove screw securing oven control panel to
frame.
3.
Pull the oven control panel outward at the top and
lift to remove from frame.
4.
Note wire locations and disconnect from the
infinite switch (1, Fig. 3) thermostat (2, Fig. 3) and
oven light (3, Fig. 3).
Fig. 3
5.
Reverse procedure to install.