EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
Fig. 25
6.
Remove thermostat from oven.
7.
Reverse procedure to install.
When installing, do not bend and kink
capillary tube or damage to the control may occur.
8.
Perform OVEN THERMOSTAT CALIBRATION.
9.
Check range for proper operation.
GRIDDLE AND HOT TOP
THERMOSTATS
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove thermostat knob.
2.
Remove thermostat mounting screws.
Fig. 26
Disconnect the
Page 13 of 33
3.
Open FRONT CONTROL PANEL.
4.
Disconnect lead wires from thermostat noting
their locations.
Fig. 27
5.
Access the underside of RANGE TOPS. The
picture below shows the thermostat bulb and
clamp for a Hot Top.
A.
To access the thermostat bulb and clamp for
a griddle, refer to GRIDDLE HEATING
ELEMENT.
6.
Remove mounting nuts (1, Fig. 28) from
thermostat bulb clamp (2, Fig. 28).
Fig. 28
7.
Remove thermostat bulb from clamp.
8.
Remove wire tie securing the insulating sheath
and capillary tube to frame.
A.
Remove insulating sheath from capillary
tube. Retain for use on replacement
thermostat capillary tube.
B.
Remove thermostat.
9.
Reverse procedure to install.
F45586 (0716)