EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
KICK PANEL
electrical power to the machine and
follow lockout / tagout procedures.
1.
Lift kick panel to disengage from the mounting
bracket upper pin and allow panel to rotate down.
Fig. 4
2.
Apply outward pressure on one of the panel
mounting ends to disengage from mounting
bracket lower pin.
3.
Reverse procedure to install.
RANGE TOPS
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove screws (2, Fig. 5) securing backsplash
(1,Fig. 5) to frame.
Fig. 5
Disconnect the
Disconnect the
Page 7 of 33
2.
Lift backsplash to disengage the support tabs
from mounting slots in frame. Place backsplash
to the side until ready to install.
3.
Open FRONT CONTROL PANEL.
4.
Remove range top as described below:
Fig. 6
A.
French Plate (1, Fig. 6) - Remove screws
securing French Plate (Fig. 7) to frame.
B.
Hot Top (2, Fig. 6) - Remove screws
securing bull nose (1, Fig. 8) to frame then
lift bull nose off range.
C.
Griddle (3, Fig. 6) - Remove screws
securing bull nose (1, Fig. 8) to frame then
lift bull nose off range.
Fig. 7
Fig. 8
F45586 (0716)