Hot Top; Griddle Heating Element - Vulcan-Hart ev12 Service Manual

EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS

HOT TOP

electrical power to the machine and
follow lockout / tagout procedures.
1. Remove RANGE TOPS.
2. Remove mounting nuts (1, Fig. 18) that hold
thermostat bulb clamp (2, Fig. 18) to the plate
assembly.
Fig. 18
3. Remove thermostat bulb clamp and thermostat
bulb from Hot Top.
4. Remove the inside terminal screws (1, Fig. 19)
from electrical connections.
Fig. 19
5. Bend hooks inward slightly (1, Fig. 20) then
remove electrical connections.
Disconnect the
Page 11 of 33
Fig. 20
6. Remove Hot Top.
7. Reverse procedure to install.
8. Check range for proper operation.

GRIDDLE HEATING ELEMENT

electrical power to the machine and
follow lockout / tagout procedures.
NOTE: 24" wide griddle shown.
1. Remove RANGE TOPS.
2. Remove thermostat bulb from the angle iron
weldment (1, Fig. 21) on the bottom of griddle
plate.
3. Disconnect element wiring from heating element
terminals (2, Fig. 21).
Fig. 21
Disconnect the
F45586 (0716)