Extron electronics IN1606 series User Manual page 115

For the variable analog output:
1. Click the tab (see
Output
2. If desired, deselect the
include the mic/line inputs in the amplified output (this is selected by default).
3. In the panel (see
Mix Options
— Outputs program audio as left and right stereo.
• Stereo Program
• Dual Mono Program
channel.
— Mutes program audio.
• No Program
For digital outputs (HDMI A, HDMI B, and Out C for IN1608 Series):
1. Click the tab (see
Output
2. If desired, click the
Mic/Line
mic/line inputs in the output.
3. In the panel (see
Mix Options
— Outputs program audio as left and right stereo.
• Stereo Program
• Dual Mono Program
channel.
— Mutes program audio.
• No Program
Output gain
Each output has a gain fader for output gain adjustment.
NOTE: The detected program audio format can be
To adjust the gain fader:
1. Click the tab (see
Output
2. If the section has multiple faders, click the
starting on page 103) to constrain the proportions between fader levels.
3. Adjust the level using any of the following methods (see
Click and drag the fader handle to the desired level.
•
Click the fader handle and press the <Up Arrow> or <Down Arrow> key to
•
respectively increase or decrease the level in 1 dB increments (PCS only).
Click the fader handle and press the <Page Up> or <Page Down> key to respectively
•
increase or decrease the level in 10 dB increments (PCS only).
Click in the level text field below the fader and enter a new value. Then, press the
•
<Enter> or <Tab> key to apply the change.
Click the or
• Up Down
increase or decrease the level in 0.1 dB increments.
4. To mute an output, click the
To optimize the output gain:
1. In the desired output section of the Web page, click the
figures 73-77, ).
5
NOTE: Meters are automatically enabled on the PCS.
2.
Set the output gain to 0 dB.
3. With program material (or pink noise) present on the input, adjust the output volume until
the meters maintain a level just below clipping.
IN1606 and IN1608 Series Scaling Presentation Switcher • Internal Web Pages
figure 69, on page 96).
4
check box (see figure
Mic/Line
figure 76, ), click the desired radio button:
2
— Sums left and right program audio and outputs it on each
figure 69, on page 96).
4
check box (see figure
figure 77, ), click the desired radio button:
2
— Sums left and right program audio and outputs it on each
figure 69, on page 96).
4
button (see
Gang
arrow button to the right of the level text field to respectively
button (see figures
Mute
76, on page 107) to not
2
77, on page 107) to include the
2
, , , or
None Analog LPCM-2Ch
figures 73 and 75-77,
figures 73-77, ):
3
73-77, ) below the desired fader.
4
check box (see
Enable Meters
.
Multi-Ch
6
109