Extron electronics IN1606 series User Manual page 107

Mic/line gain
The mic/line fader has a gain range of -18 dB to +60 dB. Adjustments increase or
Gain
decrease in 0.1 dB increments. The default setting is 0.0 dB.
The gain range accommodates a line level signal, typically from line level source devices or
a wireless microphone receiver with a line level output, or a mic level signal from dynamic or
condenser microphones.
To adjust the mic/line gain fader:
1. Click the
Mic/Line Input
2. Adjust the level using any of the following methods (
Click and drag the fader handle to the desired level.
•
Press the <Up Arrow> or <Down Arrow> key to respectively increase or decrease
•
the level in 1 dB increments (PCS only).
Press the <Page Up> or <Page Down> key to respectively increase or decrease the
•
level in 10 dB increments (PCS only).
Click in the level text field below the fader and enter a new value. Then, press the
•
<Enter> or <Tab> key to apply the change.
Click the or
• Up Down
increase or decrease the level in 0.1 dB increments.
3.
To mute the mic/line gain, click the
To optimize the mic/line gain on each microphone input:
1. Connect the desired microphone and route the mic/line input to the desired output.
2. If needed, click the
Phantom Power
3. Set the mic/line fader to 0 dB.
Gain
4. If the mic/line input is muted (the
button ( ) to unmute the mic/line input.
=
Mute
5. For Web pages, select the
NOTE: Meters are automatically enabled in the PCS.
6. While speaking into a connected microphone, adjust the mic/line
the mic/line audio input is clearly audible. Voice levels at microphone inputs can vary
significantly, so gain and meter level readings may vary. Aim to have the meter averaging
-20 dBFS to -15 dBFS to accommodate normal variances in voice intensity.
IN1606 and IN1608 Series Scaling Presentation Switcher • Internal Web Pages
tab (see figure 71, on page 99).
1
-
arrow button to the right of the level text field to respectively
button ( ) below the mic/line Gain fader.
Mute =
button (see Phantom power
button is red when the audio is muted), click the
Mute
check box (
Enable Meters
):
on page 100).
).
~
fader until
Gain
101