Panasonic KX-TDA100 Pc Programming Manual page 577

Maintenance Console Location
2.11.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
2.9.18 [2-10] Extension CID Settings—Extension Caller ID Resource-1, 2 (KX-TDA30 only)
Feature Guide References
1.18.1 Caller ID
Incoming Call Wait Timer for Extension Caller ID
Specifies the length of time that the ringing for a call is delayed when the call follows immediately after
the previous unanswered call. When receiving two calls in quick succession (e.g., when a call waiting
in a queue is directed to an extension immediately after the previous unanswered call stops ringing),
some SLTs require a pause, after the first call stops ringing, to receive the second call's Caller ID
information.
Note that for the KX-TDA30, the setting of this parameter is only effective when a resource for sending
extension Caller ID is assigned in Extension Caller ID Resource-1, 2 (KX-TDA30 only) for the port
in 2.9.18 [2-10] Extension CID Settings.
Value Range
0–15 s
Maintenance Console Location
2.11.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
2.9.18 [2-10] Extension CID Settings—Extension Caller ID Resource-1, 2 (KX-TDA30 only)
Feature Guide References
1.18.1 Caller ID
SLT MW Mode (KX-TDA100/KX-TDA200/KX-TDA600 only)
Enables the use of the Message Waiting Lamp on an SLT extension connected to the extension port.
Value Range
Disable, MW-Lamp
Maintenance Console Location
2.11.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Guide References
1.19.1 Message Waiting
2.11 [4] Extension
PC Programming Manual 577