Panasonic KX-TDA100 Pc Programming Manual page 388

2.9 [2] System
Switch CLIP of CO Line / Extension
Specifies the feature number used to send either the CLIP number of the trunk in use (subscriber's
number) or the extension to the network.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
2.9.8 [2-6-1] Numbering Plan—Main
Programming Manual References
2.8.14 [1-1] Slot—Port Property - BRI Port—ISDN CO—Subscriber Number
2.8.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO
Setting—Subscriber Number
2.11.1 [4-1-1] Wired Extension—Extension Settings—Option 1—CLIP ID
2.11.10 [4-2-1] Portable Station—Extension Settings—Option 1—CLIP ID
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
MCID
Specifies the feature number used to ask the telephone company to trace a malicious call. This
feature can be used during a call or while hearing a reorder tone after the caller hangs up.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
2.9.8 [2-6-1] Numbering Plan—Main
Programming Manual References
None
Feature Guide References
1.21.1.9 Malicious Call Identification (MCID)
ISDN-FWD (MSN) Set / Cancel / Confirm
Specifies the feature number used to set or cancel the FWD of incoming ISDN calls to an outside
party using the ISDN service of the telephone company (instead of the PBX), or confirm the FWD
setting.
Extension users can set the FWD destination to the network on an MSN basis.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
388 PC Programming Manual